Step 4 - Saiga 7.62x39 Conversion
Uploaded by: rjs3484
Video Description:
Installation of trigger guard and pistol grip. I had to use a hack saw to shorten the trigger guard a little bit. I just used a phillips screw driver to install the pistol grip.
Most of my information comes from the following sites:
http://www.cross-conn.com/Saiga_Conversion/
http://home.comcast.net/~navy87guy/home/saigaconversion.html
http://forum.saiga-12.com/
Please Note: This is my first at a conversion. I am sure I am getting some of the terminology incorrect and I know for a fact there are better and more efficient ways at doing some of the tasks. I would encourage people to visit the forums at http://forum.saiga-12.com before attempting the conversion based solely on these videos.
**
Everything in this conversion is 100% legal. This is NOT going to make the rifle fully automatic. After the conversion is complete it will be 922R compliant.
**
Tags for this video: 7.62 7.62x39 AK AK-47 Conversion Saiga
Find more videos in the "Howto" category
See more videos uploaded by rjs3484
| Step 2 - Saiga 7.62x39 Conversion | Step 3 - Saiga 7.62x39 Conversion | Step 1 - Saiga 7.62x39 Conversion |
 |  |  |
| Intro - Saiga 7.62x39 Conversion | Saiga 308 conversion | AK full auto conversion - DIAS/LL |
 |  |  |
Share This Video:
Comments for this video: Show || Hide
| Comments for this video on YouTube |
| FWIW, you should ... ( 10 months ago by WillieD7) |
| FWIW, you should probably paint (or whatever) before these steps. High Temp matte spray paint for grills works well. |
| You are correct. I ... ( 10 months ago by rjs3484) |
| You are correct. I went back before doing the BHO and painted with high heat paint from Home Depot when I had all the FCG out. |
| Good video. I just ... ( 8 months ago by Yuhsiu1) |
| Good video. I just saw one of these guns on gunsamerica converted already in 223 for 400.00..nib..good deal? |
| I'm not sure. I ... ( 8 months ago by rjs3484) |
| I'm not sure. I haven't looked into 223's much. |
| where did you get ... ( 5 months ago by temprs) |
| where did you get your pistol grip? |
| I didnt see you ... ( 3 months ago by Mittelmorder) |
| I didnt see you drill any holes, Did your saiga already have pre-cut holes for the pistol grip nut and trigger and the like? |
| Hey there again, is ... ( 2 months ago by Mittelmorder) |
| Hey there again, is there any way to figure out if my Saiga has the pistol grip hole and all that pre-drilled? I may do a conversion if the holes are already there, but if they arent i dont want to deal with the hassle. |
Tell a friend: